Here’s the STL file: http://www.thingiverse.com/thing:2007221 Below is the Cura settings when I printing this lion.
bottes ugg Soldes 2017 Asics ugg 2017 nike air max 1 pas cher ugg paillettes nike air max tavas adidas messi 2017 Because I want it to be finished quickly, I set the infill density to 5%. nike air max 90 asics soldes adidas nmd asics france air jordan 11 nike air max femme Asics 2017 This is when I take off the round support away from the lion. asics gel quantum 360 chaussure timberland homme 2018 nike air max bottes ugg adidas pas cher nike tn requin nike tn After that comes the most important part—you should use a heat gun to blow the lion’s hair,just like what you did to your own hair everyday morning~lol~ I set the temp of the heat gun to 170 degree centigrade and I think it’s the best temp to blow it’s hair which is not too hot that melt the prints but can soft it. fjällräven rucksack nike air max 90 pas cher basket new balance nike air max thea soldes asics gel lyte iii nike running homme chaussure de tennis asics Then you could design the haircut.