March 6, 2017

We are back!!!

by Su, Richard in Blog

After more than one week’s leave, cheap bns gold asics gel lyte 5 adidas zx 500 asics france nike air max 90 nike tn nike roshe run we are back now! So, nike dynamo nike air max command soldes adidas stan smith air jordan future ugg homme Nike Air Max R4 nike dynamo cast all your orders, nike kwazi soldes chaussures ugg pour femme Asics 2017 adidas ace ugg paillettes uggs pas cher adidas yeezy boost questions, nike air max pas cher bottes ugg pas cher soldes timberland adidas en ligne air jordan future adidas stan smith chaussure adidas femme suggestions,

One Comment

  1. Tremaine Bracey
    February 13, 2017 at 5:02 pm

    Hi, I have a overlord and I’m having trouble removing my prints from my build plate, I’ve tried the painters tape, glue, hair spray and finally I bought a 3D build plate and still have to fight to get my prints off of the plate. Can you help me?

    1. Richard
      February 15, 2017 at 9:55 am

      Hi Tremaine,

      Thanks for your message. Did you ever tried our build plate sticker? The black round one which replace the glass on the build plate.

    2. william
      February 16, 2017 at 9:51 am

      Hi there, there’s an advanced setting that you can change the height of first layer. Set it bigger then the nozzle will not extrude too close to the build plate. tested effective!

Leave a Reply

Your email address will not be published. Required fields are marked *